Hanging Instructions

QUICK FEEDERS must be mounted within a safe, dry, covered area.  DO NOT attempt to make modifications or changes to this product or warranty may be nullified and voided.  

INSTALLATION:  Locate your new feeder close to a 110-volt receptacle for electric power.  Mount feeder on a suitable outer stall wall OUT OF THE ANIMALS REACH  for horses and other grain fed animals.  See Figures A, B or C for mounting applications for your animal or pet.  Note:  Wall must be solid and sturdy.

Determine a mounting height that allows the PVC pipe to be directed back through the stall wall into the feed bucket as in Figure A  (feed bucket height may need to be lowered to accommodate ease in refilling the QUICK FEED hopper).  For domestic pets, install feeder according to Figures A, B or C.

For all applications locate top center mounting hole on back of hopper and mark wall.  Install screw, hang feeder on single screw, level unit and mark remaining 3 mounting holes.  Install all 4 screws using washers; tighten screws firmly.

Figure A - Typical Outer Stall Installation:  Slip PVC 45° ell (do not glue) over the spout adapter.  Determine where the PVC pipe will penetrate the stall wall and mark.  Cut hole through stall wall .  Insert PVC through hole and into PVC 45° ell.  Mark and cut off excess PVC pipe to correct length. CAUTION:  Do not leave PVC pipe protruding inside stall or feed bucket where the animal can reach it.  Cut flush with inside wall.

Figures B & C

Figures B & C - Direct Drop Installation:  After hanging feeder slip coupler over spout adapter.  Determine length for PVC pipe  and cut to size.  Slip PVC 45 ell over end if desired, slip pipe into coupler.